Creality Ender 3 Series Z-Axis Extension.
- Ender 3
- Ender 3 Pro
- Ender 3 Neo
- Ender 3 V2
- Ender 3 V2 Neo
May fit other models.
- 2x 682mm Black Anodised Aluminium Sides (Tapped both ends).
- 2x 650mm T8 Rods.
- 1x 10ml Silicone Grease.
- T-nuts & Screws (For Stepper Motors).
With these parts you will have the ability to extend your Enders Z-Axis printable build volume to a massive 500mm+, this depends on the hot end setup used, very easy too install. This setup is for those with dual Z-Axis Kits, for those that do not require the extra Rod please message us for a discount.
No mounting holes for the stepper motors (fixings supplied) & No mounting holes for the power supply as there not needed if you have a dual Z-Axis upgrade, also maybe beneficial to use supports to stabilize the frame in case of any wobbling.
If you need extended cables please check out our other listings.