Creality Ender 3 Series Z Axis All Metal Conversion Sync Timing Kit.
- Ender 3,
- Ender 3 Pro,
- Ender 3 v2,
- Ender 3 Neo.
Direct fit for Ender 3 v2, Ender 3, Pro & Neo models will require a bracket printing for relocating the power supply an STL can be easily found online.
- 1x Creality T8 365mm Standard Length (Stainless Steel).
- 1x Creality T8 Rod Nut (Brass).
- 1x Creality Z-Axis Conversion Plate (Black Anodised Aluminium).
- 2x Z-Axis Fully Adjustable Bearings (Black Anodised Aluminium).
- 2x T8 Rod 20 Tooth Timing Gears (Black Anodised or Silver Aluminium).
- 2x M8 Rod Bearing Gear Spacers (Stainless Steel).
- 1x GT2 6mm Closed Loop Belt (Black).
- 1x Tube of High Temp Super Lube PTFE Grease.
- All Creality Screws, Spacers, Spring Washers & T-Nuts (Chrome Steel).
This kit has been setup with the highest quality parts available. The kit has Z-Axis bearings which are fully adjustable and contains a proper replaceable bearings that can be attached to the Z-Axis cross bar or on the Z-Axis profile sides.
The kit is to stop the x-axis dropping on one side, the timing belt setup is based on the new Ender 3 s1 and CR6-SE etc… with no tensioner required.
All parts listed as Creality are genuine parts.
Please Note: You’ll have to have some DIY knowledge to fit this kit as there’s no instructions as of yet, however it is relatively easy to install, please use the grease and do all the rods & rod nut provided in the kit.
Although everything is brand new sometimes aluminium parts may have some very very minor marks due to how there packaged and sent to us, if you want pictures of the kit before being dispatched please ask.